Linbell G2 User Manual R/2017-04-26 (self-powered Wireless Doorbell, Batteryless)

Linbell G2 User Manual R/2017-04-26 (self-powered Wireless Doorbell, Battery-less)

To connect the receiver to the transmitter, please see "Add Coding or Delete Coding" below (Page 4)

www.linptech.com

Product of CHINA WUHAN LINPTECH CO., LTD

武汉邻普科技有限公司

Tel:+86-27-87413985  Email: service@linptech.com

=== Below is page 1====

Cover Page

=== Below is Page 2 ===

Fast Experience

(1) How to adjust the volume

(2) How to change tunes of the bell

==== Below is page 3 ===

Introduction to Installation

==== Below is page 4 ====

Add Coding or Delete Coding

(A) Add Coding

Step A1: Plug the receiver into a power point socket. Switch on the power. The receiver will ring twice and the light will flashes. 

After flashing stops, keep pressing any key on the sides of the receiver at least 3 seconds until the light keeps changing from "off" to "on" which means it is waiting for coding. Then you stop pressing the key.

Step A2: Press the transmitter and the receiver rings and flashes. Then the receiver will be connected to the transmitter.

(B) Delete Coding

Step B1: Keep pressing any key on the side of the receiver at least 10 seconds until you delete the coding.

==== Page 5 ====

Product Information 

==== Page 6 ====

Warranty Card

==================

Linbell batteryless and wireless Door bell seller

Clik-Clik Pte Ltd (formerly known as Clik-4-Deals)

=================